Installing The Battery; Charging The Battery - Kyocera 3035 - QCP Cell Phone Reference Manual

Installing the Battery

Installing the Battery
Before using your QCP 3035 phone, follow the steps below to install the battery.

Charging the Battery

Before using your phone, fully charge the battery. Connect the AC Adapter to the
proper jack on the bottom of the phone as shown below, then connect the adapter's
plug to a wall outlet.
You must have at least a partial charge in the battery to make or receive calls, regardless of
Note
whether or not the AC Adapter is connected to the phone.
The battery icon is animated as the battery is charging. The battery is fully charged
when the battery icon looks like
time, even if it has a partial charge.
Turn off the phone before charging the battery with the AC Adapter. The battery takes less
Tip
time to charge if the phone is turned off.
2
1. Align the battery door to the groove on the bottom of the
phone. Ensure that the battery slips into the small
groove located in the middle of the phone casing.
2. Push the battery in until it clicks closed. The battery
should be snug. Check and repeat if battery door is not
aligned. Do not force.
. You can safely recharge the battery at any
Reference Guide for the QCP 3035 Phone