Cool Zone Technology; Auto Cut-Out Reset Button - Breville Avance BDF200 Manual

Operating Your Breville Avance
11. When the food is cooked, raise the basket out of the
oil to drain, then turn temperature control dial back
to 150°C then turn the power 'Off' with the power
switch, then unplug the power cord.
12.
Keep the basket in the raised position for a
few minutes to drain the oil from the food
before serving.
13.
If continuing to cook allow the unit to reheat until
the 'Green' temperature light illuminates.
14.
Allow the deep fryer to fully cool before emptying
the oil or cleaning the unit.

Cool Zone Technology

COOL ZONE AREA
The submerged heating element system on the Avance
Deep Fryer allows oil to be heated more effectively, and
respond quickly to oil temperature changes.
Oil below the heating element is cooler and allows
cooked foods including crumbs to sink to the bottom of
the enamel bowl and not cook any further, tainting the
oil taste.
This allows further cooking to take place without food
particles interfering or tainting the cooked result.
The Cool Zone Technology results in less need to
change the cooking oil. Used oil can be re-used more
times than in standard deep fryers.
DURING AND IMMEDIATElY AFTER cOOKING, YOU MAY SEE STEAM RISING ThROUGh ThE FIlTER vENT
OPENINGS IN ThE lID. ThIS IS NORMAl, hOWEvER AvOID TOUchING ThIS AREA DURING cOOKING TO
PREvENT STEAM BURNS AS ThE STEAM ThAT IS GENERATED IS AT A hIGh TEMPERATURE.
AS ThE BASKET ITSElF GETS vERY hOT, ONlY USE ThE hANDlE TO hOlD OR cARRY ThE BASKET
FOR SERvING.
Deep Fryer
™
continued

Auto Cut-Out Reset Button

Always add the required amount of oil BEFORE
switching the power on at the power outlet. An Auto Cut
Out safety switch will be activated if the unit is turned
on without oil in the bowl.
To re-activate the unit, let the unit cool completely and
then reset by pushing the red button on the back of the
controller assembly above the cord storage.
™
9