Control Panel - Supero AS-4041M-32RPlus User Manual

6-2

Control Panel

The front control panel must be connected to the JF1 connector on the serverboard
to provide you with system status and alarm indications. A ribbon cable has bundled
these wires together to simplify this connection. Connect the cable from JF1 on the
serverboard (making sure the red wire plugs into pin 1) to the appropriate comnnec-
tor on the front control panel PCB (printed circuit board). Pull all excess cabling over
to the control panel side of the chassis. The LEDs on the control panel inform you
of system status - see Figure 6-2 for details. See Chapter 5 for details on JF1.
Power
HDD
NIC1
NIC2
Overheat/Fan Fail
Power Fail
Figure 6-2. Front Control Panel LEDs
Indicates power is being supplied to the system.
This LED indicates SAS/SATA hard drive activity when
fl ashing.
1
Indicates network activity on LAN port 1.
2
Indicates network activity on LAN port 2
When this LED fl ashes, it indicates a fan failure. When on
continuously it indicates an overheat condition (see Chapter
3 for details).
Indicates a power supply failure.
6-3
Chapter 6: Advanced Chassis Setup