Table of Contents
Advertisement
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position
is on pins 1 and 2 to enable VGA.
See the table on the right for jumper
settings.
JLAN Enable/Disable
Change the setting of jumper JPL1
to enable or disable the JLAN1 and
JLAN2 Gb Ethernet ports. See the
table on the right for jumper settings.
The default setting is enabled.
2
I
C to PCI-X Slots
Jumpers JI
2
C1 and JI
2
to connect the PCI-X slots to the I
(System Management) bus. The de-
fault setting is disabled. Both jumpers
must be set to the enabled or disabled
setting for this feature to function.
See the table on the right for jumper
settings.
2
I
C to PCI-E Slots
Jumpers JI
2
C3 and JI
to connect the PCI-E slots to the I
(System Management) bus. The de-
fault setting is disabled. Both jumpers
must be set to the enabled or disabled
setting for this feature to function.
See the table on the right for jumper
settings.
Chapter 5: Advanced Serverboard Setup
C2 allow you
2
C
2
C4 allow you
2
C
5-19
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
JLAN1/2 Enable/Disable
Jumper Settings (JPL1)
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
I
2
C to PCI-X Slots
Jumper Settings (JI
2
C1, JI
2
C2)
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
2
I
C to PCI-E Slots
2
2
Jumper Settings (JI
C3, JI
C4)
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
Advertisement
Table of Contents
