Troubleshooting; No Sound Coming From The Unit; Cannot Save A Preset; Clean Tone Sounds Distorted - Fender CYBER-TWIN SE Manual

Hide thumbs

Table Of Contents

Table of Contents

Appendices

Appendix

No sound coming from the unit...

Make sure MASTER, TRIM, GAIN, VOLUME, TREBLE, MIDDLE, BASS and guitar are all above "1."

Make sure nothing is plugged into the HEADPHONE jack.

Make sure you are not in Tuner mode.

Cannot SAVE a preset...

Make sure Memory Protection is disabled in Utility Mode.

Clean tone sounds distorted...

Turn Trim down if the red LED is constantly on while playing.

Reduce effects loop device levels.

The 3 FX knobs do nothing...

Press the FX button and if "None" is displayed, rotate the data wheel to select an effect.

If connected, press the FX/Reverb Bypass footswitch button.

The 4-Button footswitch does not work...

Make sure it is plugged into the footswitch jack and not a MIDI jack.

An Error message is displayed...

Write down the message exactly as it appears and contact your local Fender

mation.

The unit is not responding to any MIDI program change messages from external devices...

Make sure the MIDI Receive channel is set properly.

Make sure the MIDI Cables are connected properly.

The unit is not responding to any MIDI Continuous Controller Messages from external devices...

Make sure the MIDI Receive channel is set properly.

Make sure the continuous controller numbers matches the value in the UTILITY menu or is one of the pre-

defined numbers listed in the appendices.

Make sure the MIDI Cables are connected properly.

The unit is not responding to any System Exclusive Information from external devices...

Make sure the System Exclusive Device ID is set properly.

Make sure the MIDI Cables are connected properly.

General MIDI questions...

Visit www.midi.org

Problem still persists after trying these solutions...

Consult an authorized Fender

click on support.

w w

w . . f f e

e n

n d

d e