Peak And Midi Leds; Hum Reduction; Fx Level / Fx Val 1 / Fx Val 2; Display And Data Wheel - Fender CYBER-TWIN SE Manual

w w w w w w . . f f e e n n d d e
N. PEAK and MIDI LEDs
PEAK flashes when the DSP circuit is clipping (distorting). Reduce
VOLUME if undesirable distortion is heard while this LED is on, then use
MASTER to the increase loudness level.
MIDI is on when the Cyber–Twin SE™ is communicating MIDI
information.
O. HUM REDUCTION
Turns hum reduction on/off.
situations using a patented algorithm that seeks out line frequencies and
squelches only the hum, without degrading your music!
P. FX LEVEL / FX VAL 1 / FX VAL 2
Adjusts the level, parameter 1 and parameter 2 of the active effect,
respectively. The functions of these knobs as well as additional parameters
can be accessed through the FX edit mode (see page 16).
Q. DISPLAY and DATA WHEEL
Your interface for controlling the dynamic functions described throughout
this manual (See the Overview on page 8).
R. PRESET EDIT
The AMP and FX buttons activate the AMP and FX (effects) edit modes
respectively. For the AMP edit menus see page 14; FX edit menus see
page 16.
S. UTILITY
Activates the UTILITY mode. For the UTILITY edit menus, see page 24.
T. EXIT
Activates the default PLAY mode (except during factory preset restore and
MIDI data transfers).
U. BLUE JEWEL
It's still a
e r r . . c c o o m m
Front Panel Overview
Reduces environmental hum in some
w w w w w w . . m m r r g g e e a a r r h h e e a a d d . . n
11
n e e t t