Nikon F80 - F 80 SLR Camera Instruction Manual page 63

Nikon
8 Set the minute following steps 6 and 7. When the
setting is complete, push the SELECT button twice so
the newly adjusted time display appears without
blinking.
• To set time to the precise second, push the SELECT button once at the
step 8 so : indication blinks. When the actual time coincides with the time
you have set, push the ADJUST button. The clock starts from 00 sec.
(Seconds are not displayed in the LCD panel.)
Example: To set the clock to 13:00:00:
Set the clock to 13:00. Push the SELECT button so : indication blinks.
When the time becomes exactly 13:00:00, push the ADJUST button to start
the clock at exactly 13:00:00.
• Batteries in the camera body also power the Quartz Date. Set the date and
time after installing batteries for the first time. When changing batteries,
date and time remain in the Quartz Date memory up to approx. 15 minutes
without batteries. If the date and time data are lost, reset them.
• Imprinting date/time
Push MODE button to select date/time display and fully
depress the shutter release button to take a picture with
the imprinted date/time.
• The data displayed on the data imprint LCD will be imprinted on the
picture. Select - - - - - - (no imprint) to cancel data imprint. Compatible
film speeds for data imprinting are IS032-3200.
• Data imprint indicator - blinks for approx. two to three sec. immediately
after the shutter is released (when a film is loaded).
Distributed by WWW.LENSINC.NET
file:///D|/CAMERA REPAIR/Nikon F80/F80.htm (63 of 78) [3/19/2004 11:39:25 PM]
• Pushing the SELECT button once makes : blink and pushing it a second
time makes — appear. When — appears, the setting is complete.