Nikon
When the camera is turned on,
film is loaded and the camera
back is closed, the film
automatically advances to the
first frame.
3.1 Turn the power switch on, confirm that the film
speed setting is set to DX, then open the camera
back by sliding the camera back lock release lever.
• If the film speed setting is not set to DX, see page 36.
3.2 Insert film from the bottom side and pull film leader
out to red index mark.
• Do not insert the film leader beyond the red index mark.
NOTE: Loading/removing film
Shutter curtains are very thin. Do not
touch the shutter curtains with your finger
or the film leader.
Check points
To change film speed with DX-coded film or select film advance mode,
see pages 36-37.
Shutter curtains are very thin. Do not touch the shutter curtains with
your finger or the film leader.
Avoid direct sunlight when changing film outdoors.
3.3 Hold the film cartridge and ensure film is properly
positioned with no slack, then gently close the
camera back until the camera back snaps closed.
Film automatically advances to the first frame.
Distributed by WWW.LENSINC.NET
file:///D|/CAMERA REPAIR/Nikon F80/F80.htm (13 of 78) [3/19/2004 11:39:24 PM]