Dell POWEREDGE EMU01 Hardware Owner's Manual page 19

Table 1-7. LCD Status Messages (continued)
Line 1 Line 2
Message Message
E1414 CPU # Thermtrip
E1418 CPU # Presence
E1423 CPU # VRM
Missing
E141C CPU Mismatch
E141F CPU Protocol
E1420 CPU Bus PERR
E1421 CPU Init
Causes
Specified microprocessor is out of
acceptable temperature range and
has halted operation.
Specified processor is missing or
bad, and the system is in an
unsupported configuration.
VRM for specified processor is
missing or faulty.
Processors are in a configuration
unsupported by Dell.
The system BIOS has reported a
processor protocol error.
The system BIOS has reported a
processor bus parity error.
The system BIOS has reported a
processor initialization error.
Corrective Actions
See "Troubleshooting System
Cooling Problems" on page 105.
If the problem persists, ensure
that the microprocessor heat
sinks are properly installed. See
"Troubleshooting the
Microprocessors" on page 114.
NOTE:
The LCD continues to
display this message until the
system's power cord is
disconnected and reconnected to
the AC power source, or the SEL is
cleared using either Server
Assistant or the BMC Management
Utility. See the Dell OpenManage
Baseboard Management
Controller User's Guide for
information about these utilities.
See "Troubleshooting the
Microprocessors" on page 114.
Remove and reseat the specified
VRM. See "Processor VRMs" on
page 66.
If the problem persists, the
system board is faulty. See
"Getting Help" on page 129.
Ensure that your processors
match and conform to the type
described in the Microprocessor
Technical Specifications outlined
in your system's Getting Started
Guide.
See "Getting Help" on page 129.
See "Getting Help" on page 129.
See "Getting Help" on page 129.
About Your System
19