Removing Memory - Dell DIMENSION 5100 User Manual

5 Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the
module.
6 Replace the computer cover.
NOTICE:
the computer.
7 Connect your computer and devices to electrical outlets, and turn them on.
8 Right-click the My Computer icon and click Properties.
9 Click the General tab.
10 To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Removing Memory

CAUTION:
Product Information Guide.
NOTICE:
from your body before you touch any of your computer's electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 53.
2 Press out the securing clip at each end of the memory module connector.
3 Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from
the connector.
66
Removing and Installing Parts
To connect a network cable, first plug the cable into the network device and then plug it into
Before you begin any of the procedures in this section, follow the safety instructions in the
To prevent static damage to components inside your computer, discharge static electricity