Advertisement
Advertisement
Table of Contents
Related Manuals for Jensen JMD200
Summary of Contents for Jensen JMD200
- Page 1 JMD200 AM/FM/CD AUDIO SYSTEM Installation and Operation Manual PUSH POWER...
-
Page 2: Table Of Contents
JMD200 CONTENTS System Features ....................1 Safety Information ....................2 Installation ......................3 Basic Operation ....................6 Tuner Operation ....................8 CD Player Operation ................... 9 Care and Maintenance..................10 Troubleshooting....................10 Specifications ....................11... -
Page 3: System Features
JMD200 SYSTEM FEATURES Features of the Jensen JMD200 mobile audio system include: • AM/FM Tuner with 30 Presets (12 AM, 18 FM) • Single In-Dash CD Player • Mute • Electronic Bass, Treble, Balance and Fader Controls • Clock Content List •... -
Page 4: Safety Information
JMD200 SAFETY INFORMATION Disc Maintenance When Driving Keep the volume level Iow enough to be aware of the road and traffic conditions. • A dirty or defective disc may cause sound dropouts while playing. Before playing, wipe When Washing your Vehicle the disc using a clean cloth, working from the center hole towards the outside edge. -
Page 5: Installation
JMD200 INSTALLATION Before You Begin to a secure part of the dashboard, either above or below the radio using the screw and flange nut provided. Bend the strap to position it as necessary. Disconnect Battery Before you begin, always disconnect the battery negative terminal. - Page 6 JMD200 Wiring Diagram...
-
Page 7: Removing The Unit
JMD200 Reconnecting the Battery When wiring is complete, reconnect the battery negative terminal. Removing the Unit To remove the radio after installation, insert the removal keys straight back until they click, and then pull the radio out. If removal keys are inserted at an angle, they will not lock properly to... -
Page 8: Basic Operation
JMD200 BASIC OPERATION NOTE: CD mode will be skipped if no CD is inserted. Reset Use a ball point pen or thin metal object to press the RESET button (11). The reset button should be activated for the following reasons: •... - Page 9 JMD200 Time/Frequency Display Selector (T/F) Displaying the Clock Press the T/F button (10) to display the time of the incorporated quartz clock for 5 seconds. Setting the Clock To set the clock, first turn the vehicle ignition and radio on.
-
Page 10: Tuner Operation
JMD200 TUNER OPERATION Select a Band Automatically Store / Preset Scan (A/PS) Press the BND button (3) to change between three FM bands and two AM bands. Automatically Store • During FM operation, when the station is broadcasting in stereo, the stereo icon ( Select an AM or FM band. -
Page 11: Cd Player Operation
JMD200 CD PLAYER OPERATION Inserting and Ejecting a Disc Controlling Disc Playback Insert a disc, label-side up, into the disc slot (7). The unit will automatically draw the disc in and Selecting Tracks play the first track on the disc, whether the power was turned on or not. -
Page 12: Care And Maintenance
JMD200 CARE AND MAINTENANCE TROUBLESHOOTING • Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain Symptom Cause Solution minerals that can corrode the electronic circuits. • Keep the product away from dust and dirt, which can cause premature wear of parts. -
Page 13: Specifications
JMD200 SPECIFICATIONS Signal to Noise Ratio..........> 55 dB Channel Separation . - Page 14 ASA Electronics Corporation www.asaelectronics.com © 2007 ASA Electronics Corporation v.080207...