NOTE: A disc may become scratched (although not enough to make it unusable) depending on how you handle it and other conditions in the usage environment. These scratches are not an indication of a problem with the player. JCDWIN Diameter/ Playback Time...
JCDWIN INSTALLATION Before You Begin Disconnect Battery Before you begin, always disconnect the battery negative terminal. Remove Transport Screws Important Notes • Before final installation, test the wiring connections to make sure the unit is connected properly and the system works.
Page 4
Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected. GROUND Connect to ground terminal or clean, unpainted metal part of chassis. JCDWIN A- A SHOWN FROM PIN VIEW...
JCDWIN BASIC OPERATION Power On/Off ( ) Press the button (1) to turn the unit ON or OFF. Volume Control To increase the volume, turn the AUDIO control (4) clockwise. To decrease the volume, turn the AUDIO control counter-clockwise. If using the remote control, press the VOL /\ or VOL \/ button (24) to adjust the volume.
Select a band (if needed), then select a station. Hold a preset button (9-14) for three seconds. The preset number will appear in the display. Recall a Station Select a band (if needed). Press a preset button (9-14) to select the corresponding stored station. JCDWIN...
Page 7
JCDWIN Automatically Store / Preset Scan (AS/PS, AMS) Automatically Store Select a band (if needed). Press the AS/PS button (16) on the control panel (or the AMS button on the remote control) for more than three seconds to automatically select six strong stations and store them in the current band.
The signals are too weak ERROR 1 Mechanism Error ERROR 2 Servo Error JCDWIN Solution If the power supply is properly connected to the vehicle acces- sory terminal, switch the ignition key to “ACC”. Replace the fuse. Remove the disc in the player and insert the new one.