Related Manuals for Jensen JCD2006
Summary of Contents for Jensen JCD2006
- Page 1 JCD2006 MOBILE CD PLAYER / RECEIVER Installation and Operation Manual CD PLAYER / RECEIVER JCD2006 WATTS X 4 AS PS...
-
Page 2: Safety Information
SAFETY INFORMATION When Driving Keep the volume level Iow enough to be aware of the road and traffic conditions. When Washing your Vehicle Do not expose the product to water or excessive moisture. Moisture can cause electrical shorts, fire or other damage. When Parked Parking in direct sunlight can produce very high temperatures inside your vehicle. -
Page 3: Installation
INSTALLATION Before You Begin Disconnect Battery Before you begin, always disconnect the battery negative terminal. Remove Transport Screws Important Notes • Before final installation, test the wiring connections to make sure the unit is connected properly and the system works. •... - Page 4 Carefully unsnap the plastic trim ring from the front of the new radio chassis. Remove and discard the trim ring. Remove the factory mounting brackets and hardware from the existing radio and attach them to the new radio. Select a position where the screw holes of the bracket and the screw holes of the main unit are aligned (are fitted).
- Page 5 WIRING 688A 15 AMP FUSE 20-PIN AUDIO/POWER HARNESS (See Figure 1) REAR LINE OUT GREY LEFT FRONT RIGHT FRONT WHITE-BLACK LF- GREY-BLACK RF- WHITE LF+ GREY RF+ RIGHT REAR LEFT REAR GREEN-BLACK LR- VIOLET-BLACK RR- VIOLET RR+ GREEN LR+ ANTENNA SOCKET ANTENNA JACK RCA-TO-RCA CABLE...
-
Page 6: Basic Operation
With the clock displayed, press the DISP button (10) until the LCD flashes. Press the TUNE up >>| (7) button to adjust the minutes or the down TUNE |<< button to adjust the hour. Reset JCD2006 After releasing the control panel, use a pencil or any non-metallic AS PS object to press and hold the RESET button for five seconds to reset the main unit. -
Page 7: Tuner Operation
Select a band (if needed). Press the AS.PS button (3) to scan stations stored in the current band. The unit will pause for five seconds at each preset station. Press AS.PS again to stop scanning when the desired station is reached. JCD2006 AS PS... -
Page 8: Controlling Disc Playback
JCD2006 CD OPERATION CD PLAYER / RECEIVER JCD2006 WATTS X 4 AS PS Insert and Eject Disc Insert a disc, label-side up, into the disc slot (2) with the unit turned on. “CD” will display on the LCD for about 2 seconds and the unit will play the first track on the disc. Press the eject button (4) to stop disc play and eject the disc. -
Page 9: Specifications
SPECIFICATIONS Signal to Noise Ratio..........> 70dB Sampling Frequency . - Page 10 JCD2006 ASA Electronics Corporation www.asaelectronics.com © 2006 ASA Electronics Corporation v.081706...