NEC Versa 2500 Series Manual page 68

Setting an Initial System Password
Set an initial password as follows.
Select Security from the menu bar.
1.
Select "Set Password" by pressing
2.
3. At the prompt, enter a password up to seven characters
long. Then, as prompted, reenter your password for
verification. Write your password down and keep it in a
secure place in case you forget it.
Press to return to the Security screen.
4. Enter
If you want to require the password each time you start
5.
your system, move the cursor to "Password on boot"
and select "Enabled."
If you want to require the password each time the system
6.
resumes from Suspend mode, move the cursor to
"Password on Resume" and select "Enabled."
7. Press ESC to display the Exit screen. Here you can se-
lect "Save Changes and Exit" to save your password and
reboot your system.
You will have three attempts to enter the password cor-
rectly. After the third attempt, the system will be dis-
abled. Press the Power button to reboot the system and
try to reenter the password.
Removing a Password
To remove a password, press
Press Enter at "Enter new password" and press
again at "Re-enter new password." Your password
clears and you are no longer prompted to enter one.
You can also use the "Enter new password" and "Re-
enter new password" prompts to change to a new pass-
word.
.
Enter
at "Set Password."
Enter
Using Setup and Power Management 3-9
Enter