Table of Contents
Advertisement
Type exit and press
7.
Whenever you restart your system in MS-DOS mode,
the serial mouse is available; the VersaGlide is not.
To enable the VersaGlide in MS-DOS mode, remove the
/C1 that you added from the line in dosstart. This disables
the serial mouse in MS-DOS mode and enables the
VersaGlide.
Windows for Workgroups Systems
Follow these instructions to add a serial mouse to your
Windows for Workgroups system. Adding a serial mouse
and modifying the AUTOEXEC.BAT file as described here
disables the VersaGlide. If you boot your system without
the serial mouse attached, you will have no VersaGlide or
mouse functions.
1.
From the Program Manager File menu, select Run.
2.
Enter the following command and press the OK button.
Locate the following line in the AUTOEXEC.BAT file:
3.
Modify the line by adding
4.
line should look like the following:
5.
Press File, Exit, and Yes to save the change.
Press
6.
Press
7.
Windows to reload.
Setup your serial mouse drivers as follows:
8.
to return to Windows 95.
Enter
sysedit
C:\SYNTOUCH\SYNTOUCH
/C1
C:\SYNTOUCH\SYNTOUCH /C1
and press the OK button to exit Windows.
Alt-F4
to reboot your system and wait for
Ctrl-Alt-Del
Using Your NEC Versa Computer 4-35
to the end of the line. The
Advertisement
Table of Contents
