NEC Versa 2500 Series Manual page 132

MESSAGE
Diskette drive A
failure or
No Floppy Drive
General Failure
Reading Drive A
or
Diskette Read Failure –
press to run Setup.
F2
Press any other key to
retry boot
Non-system disk or
disk error; Replace
and press any key
when ready
Operating System Not
Found
or
Fixed Disk Failure 0
Invalid configuration
information – run Setup
program
7-4 Solving Problems
POST Error Messages
WHAT TO DO
Drive A does not work or is not properly connected.
Drive A is the diskette drive.
Check that drive A is securely connected and power
is on.
Press to start Setup to check the diskette drive
F2
parameters.
If there's still a problem, the drive might need repair.
Remove the diskette from drive A and press
start the system from the hard disk.
Or, insert a bootable disk in drive A and press any
other key.
Remove the diskette from drive A or CD from the
CD-ROM reader and press any key to start the
system from the hard disk.
Or, insert a bootable disk in drive A and press any
key.
Press to start Setup. Change the hard disk type to
F2
the correct setting. Exit and save Setup changes.
One or more system configuration parameters are
not properly set. Start Setup, set them correctly, and
exit and save to update the parameters.
to
F2