NEC Versa 2500 Series Manual page 133

MESSAGE
Real time clock
failure
Time-of-day not set –
run Setup
System CMOS
Checksum Bad – run
Setup
or
Press (F1) to resume,
(F2) to setup.
Fixed disk configuration
error
Fixed disk failure
Fixed disk controller
failure
POST Error Messages
WHAT TO DO
Set time and date using Setup. Exit and save to
update the parameters.
Set the time and date using Setup. Exit and save
Setup changes to update the parameters.
Press F2 to enter Setup. Under Exit, set the default
values. Under Main, set the date and time. Save
your changes and exit.
Start Setup. Exit and save to update the parameters.
Check to see if the hard disk connector is seated
properly. If there is still a problem, the hard disk
might need repair.
Press F2 to start Setup. Exit and save to update the
parameters.
Check to see if the hard disk connector is seated
properly.
If there is still a problem, the hard disk might need
repair.
Press F2 to start Setup. Exit and save to update the
parameters.
Check to see if the hard disk connector is seated
properly.
The hard disk controller does not work and might
need repair.
Solving Problems 7-5