Removing A Dimm Module - NEC POWERMATE CT 815 Manual

Removing a DIMM Module

If your memory configuration requires the removal of a DIMM module,
use the following steps.
boards or DIMM modules, reduce static discharge by touching the chassis.
Remove the cover (see "Removing the Cover").
1.
Locate the DIMM sockets on the system board (see the figure
2.
"Locating the DIMM and processor sockets" earlier in this section).
3. Eject a DIMM module by pressing the plastic clips at the outer edges
of the socket away from the module.
Removing a DIMM module
Grasp the center of the module and pull it out of the socket.
4.
Store the module in an anti-static bag.
5.
6. If you are installing a DIMM, see "Installing a DIMM Module" in the
previous section.
7. If you are not installing a DIMM module, replace the system cover
(see "Replacing the Cover").
4-20 Installing Options
Before opening the system and before handling
A – Plastic Clip (2)