Using Hard Disk Drive Password Protection - NEC POWERMATE CT 815 Manual

3. Highlight Assign HDD Password
If you enter the current master password, you are prompted to
!
enter a new master password.
If you enter the current user password, you are prompted to enter
!
the new user password.
If you do not want to establish a new master or user password,
!
press
Esc
Save the changes and exit BIOS Setup.
4.

Using Hard Disk Drive Password Protection

To facilitate the transfer of one or more HDDs between systems, establish
a single master password (and store the password in a secure place).
Forgetting the master password results in the inability to access the data
on the hard drive. Establish different user passwords to limit access to
specific systems.
hard drive, you can never remove the passwords. You can change the
passwords. If you forget the master password and install the drive in
another system, you cannot access the data on the hard drive.
Once you set these passwords, NEC Computers Inc. has no
capability of removing them.
If you install the hard drive in another PowerMate system with hard disk
drive security enabled, you must enter the password to allow access to the
hard drive. If this PowerMate system does not support hard disk drive
security, you cannot access the data on the hard drive.
With hard disk drive security enabled on the original NEC PowerMate CT
815 system, the system boots normally.
If you install the hard drive in another NEC PowerMate system with
security enabled, you must enter the master password to access the hard
drive. If the hard drive is installed in another NEC PowerMate CT 815
system with security disabled, the system prompts you to enter the master
password and then a new user password.
and press
instead of entering a new password.
If you set the master and user password on a
Configuring the System 3-23
Enter .