1/2-Inch Accessible Device Upgrade; Installing A 3 1/2-Inch Accessible Device - NEC POWERMATE CT 815 Manual

3 1/2-Inch Accessible Device Upgrade

The following sections describe how to install or remove a 3 1/2-inch
accessible device (such as a Zip drive) in a 3 1/2-inch accessible device
bay.
If you are installing a 3 1/2-inch device in an empty bay, use the
following procedure. If you need to remove a device to empty a bay, see
"Removing a 3 1/2-Inch Device" later in this section.

Installing a 3 1/2-Inch Accessible Device

Installing a 3 1/2-inch accessible device requires
removal of the cover and front panel
!
unplugging the signal and power cables from an installed device
!
removal of the two-device bracket and its cover
!
removal of the blank panel and metal panel from the bracket
!
installation of the device in the bracket
!
installation of the two-device bracket in the chassis
!
connecting the signal and power cables to the device
!
replacing the front panel and cover.
!
Install the 3 1/2-inch device as follows.
Remove the system unit cover and front panel (see "System Unit
1.
Covers").
power and unplug the system power cable. Power is removed only when
the power cable is unplugged.
Before removing the cover, turn off system
Installing Options 4-35