Diagnostics Tab - SMC Networks HPAV-ETH2 - annexe 1 User Manual

Set Local Device Only
This button is used to change the private network name of the local device only.
If a new private network name (other than HomePlugAV) is entered, all the
devices that appeared in the lower panel of the Main screen will disappear,
effectively isolating the local device from the other devices in the logical network.
Only devices that were previously set up with the same private network name
still appear in the device list.
Set All Devices
This button is used to change the private network names of all the devices that
appear in the lower panel of the Main screen and whose password has been
entered. For these devices a dialog box appears, indicating successful operation.
For devices whose passwords has not been entered, a dialog box appears
indicating operation failure.
Note: Before clicking "Set All Devices" please make sure that the
password for all HomePlug AV devices that should join the private network
has been entered . If you skip this step and you lose connectivity to some
devices, please reset the private network name to default, click on "Set All
Devices" and start all over.

5.3 Diagnostics Tab

The Diagnostics screen shows the system information and a history of all
devices that appeared in the network over a period of time. See Figure 5-5.
The Upper panel shows technical data about the software and hardware of the
host computer where the utility is running on. It includes the following:
Operating System Platform/Version
Host Network Name
User Name
MAC Address of all NICs (Network interface card) connected
14