SMC Networks HP1D-USB Manual page 7

Installing USB Driver
To install the USB drivers for the SMC EZ Connect Powerline to USB Adapter follow the steps
outlined below.
1. Put the EZ Install CD into your CD-ROM drive. The wizard will auto-run.
2. Click on the [Install USB Drivers] option
3. When the USB drivers are installed, you will be prompted to connect your SMCHP1D-USB
adapter to your PC and then reboot your PC.
Click [OK] and then close all your open applications and manually reboot your PC.
4. When you computer boots back up, the New Hardware wizard should launch and guide you
through the installation of the USB Adapter. During the Driver Installation if you are
prompted with following window:
Click the [Continue Anyway] button to complete the installation.
Note: If the wizard is unable to locate the USB drivers you can manually install the drivers by
browsing to the Drivers folder on the CD-ROM.
When you have finished installing the USB to Powerline Adapter, if this is the PC you are going to
manage your Powerline network from, then install the EZ Configuration Utility – steps are outlined
below.