Aiwa Z-R555 Operating Instructions Manual page 6

CD
DEMO
b
To turn the unit on
Press one of the function buttons (TAPE, TUNER/BAND, VIDEO/
AUWPHONO, CD). Playback of the inserted disc begins, or the
previously tuned station is received (Direct Play Function).
POWER is also available.
When the unit is turned on, the disc compartment may open and
close to reset the unit.
To
turn
the power off
Press POWER.
Flash window
The window on the top of the unit lights up or flashes while the
unit's power is on.
To turn off the light of the top window, press while pressing
CD. To turn back on, repeat the above.
Game Demo
When the AC cord is connected, the display window demonstrates
the game Demo. When the power is turned on, the game Demo
is overridden by the operation display. When the power is turned
off, the game Demo is restored.
To cancel the
game Demo
Press DEMO. To re-activate the game Demo, press
DEMO
again.
To play the game Demo
1
Press
DEMO so
that the game Demo displays.
2 Press -.
Three numbers on the display start to run.
3 Press once.
The number on the left side stops.
4 Press 9 twice to stop the remaining two numbers.
Scoring:
20 points are given to start the game.
If all the numbers are eaual, 50 points are added to the score.
If not eaual, one point is subtracted.
If the gained points reach 9999, you win.
If the gained points fall to O, you lose.
To reset the game Demo
Press DEMO twice, then press -. The game starts again.
m
During playing the game Demo, and E are available only
for the same Demo. Cancel the ciame Demo to use these
1
2
3
I ib----
1
—til
!
Press CLOCtVDIMMER once, then press ENTER
within 4 seconds.
When using the remote control
Press CLOCK whiIe pressing SHIFT, then press llSETwitbiD
4 seconds.
Turn MULTI JOG to designate the hour, then press
ENTER.
The hour stops flashing and the minute starts flashing.
Turn MULTI JOG to designate the minute, then
press ENTER.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To display the current time
Press
CLOCWDIMMER
once. The time is displayed for 4
seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press
CLOCK/DIMMER
once and then press within 4
seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
* 44 and W are also available instead of MULTI JOG.
* IISET is also available instead of ENTER.
buttons ;or other functions such as-CD playing, etc.
During the game Demo, some indicators unrelated
actual operation light up on the display.
with the
5
ENGLISH