Aiwa Z-R555 Operating Instructions Manual page 11

" When Ioadina an 8-cm (3-inch) disc, make sure to ~lace it onto
the inner circle of the trav p reciselv. Otherwise, the disc may
be damaged or the disc compartment will not open. If it does
not open, please consult your Aiwa dealer for repair.
Do not place more than one compact disc on one disc tray.
Do not tilt the unit with discs loaded, Doing so may cause
malfunctions.
When transporting the unit, remove the discs from the trays.
When replacing the discs during play, do not replace discs other
than those facing you.
If you place a disc on the empty right inner tray, and then press
A OPEN/CLOSE, "ERROR" is displayed and the disc
compartment may not close. Remove the disc on that tray.
Use the remote control.
RANDOM play
All the tracks on the selected disc or all the discs can be played
randomly.
REPEAT play
A single disc
or all the discs can be played repeatedly.
Press RANDOM/REPEAT while pressing
SHIFT .
Each time it is pressed, the function can be selected cyclically.
RANDOM play — RANDOM lights up on the display.
REPEAT play — ~ lights up on the display.
RANDOM/REPEAT play — RANDOM and C& light
up on the
display.
Cancel —
RANDOM and C& disappear from the display.
To
plav all discs,
press E to start play.
To
Wav a sincrle disc,
press one of DISC DIRECT PLAY 1-5 to
start play.
To select disc 4 or 5 from the remote control, press DISC DIRECT
PLAY 4 or 5 while pressing SHIFT.
During random play it is not possible to skip to the previously
played track with <.
Up to 30 tracks can be programmed from any of the inserted
discs.
-
2
1
3
1
u,>
5
u
Q ,
-—.
Use the remote control.
1
2
3
Press PRGM while pressing SHIFT in stop mode.
"PRG" is displayed
Press one of DISC DIRECT PLAY 1-5 to select a
disc.
To select disc 4 or 5, press DISC DIRECT PLAY 4 or 5 while
pressing SHIFT.
Go to the next step when the tray stops rotating.
Press numbered buttons O-9 and +10 to program
a track.
Example:
To select the 25th track, press +10, +10 and 5.
To select the 10th track, press +10 and 0,
Selected track number
4
5
I
Program number
Total number of selected tracks
I
Total play;ng time of the
selected tracks
Repeat steps 2 and 3 to program other tracks.
Press - to start play.
To
check the program
Each time < or - is pressed
in stop mode, a disc number,
track number, and program number will be displayed.
To clear
the program
Press CLEAR in stop mode.
To
add tracks to the program
Repeat steps 2 and 3 in stop mode, The track will be programmed
after the last track.
To
change the programmed tracks
Clear the program and repeat all the steps again
To play
the
programmed tracks repeatedly
After programming the tracks, press RANDOM/REPEAT
repeatedly while pressing SHIFT until ~ appears on the display.
m
During programmed play, you can not use random play, check
the remaining time or select a disc or track.
ENGLISH 10