Figure 15: Making Twisted-Pair Connections - SMC Networks 8028L2 Installation Manual

| Making Network Connections
C 4
HAPTER
Twisted-Pair Devices
C
ONNECTING TO
Attach one end of a twisted-pair cable segment to the device's RJ-45
1.
connector.

Figure 15: Making Twisted-Pair Connections

If the device is a network card and the switch is in the wiring closet, attach
2.
the other end of the cable segment to a modular wall outlet that is
connected to the wiring closet. (See the section
Connections.") Otherwise, attach the other end to an available port on the
switch.
Make sure each twisted pair cable does not exceed 100 meters (328 ft) in
length.
Avoid using flow control on a port connected to a hub unless it is
N :
OTE
actually required to solve a problem. Otherwise back pressure jamming
signals may degrade overall performance for the segment attached to
the hub.
As each connection is made, the Link LED (on the switch) corresponding to
3.
each port will light green (1000 Mbps) or yellow (10/100 Mbps) to indicate
that the connection is valid.
PC , S
S ERVERS
, H S
UBS AND
"Network Wiring
– 56 –
WITCHES