Figure 11: Attaching The Adhesive Feet - SMC Networks 8028L2 Installation Manual

| Installing the Switch
C 3
HAPTER
Mounting
If installing a single switch only, turn to "Connecting to a Power Source" at
3.
the end of this chapter.
If installing multiple switches, mount them in the rack, one below the other,
4.
in any order.
D S
ESKTOP OR
Attach the four adhesive feet to the bottom of the first switch.
1.

Figure 11: Attaching the Adhesive Feet

8
2
7
2
Set the device on a flat surface near an AC power source, making sure there
2.
are at least two inches of space on all sides for proper air flow.
If installing a single switch only, go to "Connecting to a Power Source" at the
3.
end of this chapter.
If installing multiple switches, attach four adhesive feet to each one. Place
4.
each device squarely on top of the one below, in any order.
M
HELF OUNTING
– 46 –