Stacking - SMC Networks 6900FSC Installation Manual

I
NSTALLING THE

Stacking

A stack may have as many as four switches.
Note: A stacking cable is included with the Stack Module.
Caution: DO NOT stack TigerSwitch 10/100 units with other
To stack the devices:
1. Locate the stack connectors labeled "UP" and "DOWN" on the
stack modules (see Figure 3-4).
2. Attach one end of the stacking cable to the stack connector
labeled "DOWN" on the top device, and the other end to the
connector labeled "UP" on the next lower device.
3. Repeat this step until all the devices have been connected.
4. Turn to the next section, "Connecting to a Power Source."
Figure 3-4. Stacking the Switches
3-6
S
WITCH
devices. Doing so may damage the switch.