Preparing The Remote Control; Initial Operation; Checking The Vehicle Functions - VDO DV 6100 Installation And Owner's Manual

Hide thumbs Also See for DV 6100:

Table of Contents

INSTALLATION INSTRUCTIONS

Securing the DVD player using the mounting brackets, Fig. 5

If installation of the DVD Player in a DIN slot is impossible or undesirable, it can be installed

in alternative installation locations using the supplied mounting brackets (e.g., in the glove

box, in the luggage compartment or under the seats).

Attaching mounting brackets

Fasten the brackets to the player housing using the supplied screws.

The DVD player can then be secured in the desired installation location using suitable

screws.

Suspended installation

If suspended installation is required for the DVD player (e.g., under the rear shelf), the

mounting brackets can be attached to the player in the reversed position.

Preparing the remote control

Inserting the batteries

Open the battery compartment on the

back of the remote control.

Insert two new AAA size batteries. Pay

attention to correct polarity (marked in

the compartment).

Close the battery compartment.

1. Reconnect the battery.

2. Restore complete functioning of the electrical system (clock, onboard computer, alarm

system, airbag, immobiliser, etc.).

3. Switch on the ignition.

4. Press the I button on the front of the DVD Player. Then activate the R button with

either a ballpoint pen or thin metal object.

5. Insert a DVD/VCD/Audio CD or MP3 disc into the DVD Player.

6. Check the perfect functioning of audio and video in combination with the installed

multimedia system. Refer to the instructions in the user manual part of this booklet.

Check the safety-relevant vehicle functions only when the car is stationary or moving at low

speed. Only perform check in an open area.

Brake system, alarm system, lights, immobiliser, speedometer, onboard computer, clock.

–

Table of Contents