Table of Contents
Advertisement
Display
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically
touching an unpainted metal surface (such as a connector on the back of the computer).
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin working inside
the computer.
1 Follow the procedures in "Before You Begin" on page 75.
2 Remove the hinge cover. See "Hinge Cover" on page 89.
3 Remove the four screws securing the display.
4 Disconnect the antennae cables (pull to separate the connectors).
5 Remove the grounding wire screw.
6 Disconnect the display cable, using the pull-tab.
display cable trough
7 Lift the display up and away from the computer.
grounding wire screw
display cable pull-tab
antenna cables
screws (4)
antenna cable clip
display cable connector
on system board
Adding and Replacing Parts
87
Hide quick links:
Advertisement
Table of Contents
