Low Beam Bulb - APRILIA SL MILLE - PART 3 1999 Manual

LOW BEAM BULB

CAUTION
To extract the bulb electric connector,
do not pull its electric wires.
N
Grasp the bulb electric connector (10),
pull it and disconnect it from the bulb (3).
N
Move the protection element (11) with
your hands.
N
Release the check spring (12) positioned
at the rear of the bulb socket (13).
N
Extract the bulb (3) from its seat and re-
place it with a new one of the same type.
NOTE
Insert the bulb in the bulb socket,
making the relevant positioning seats coin-
cide.
Carefully read p. 81 (BULBS).
N
Position the vehicle on the side stand on
firm and level ground.
N
Unscrew and remove the screw (14).
NOTE
While removing the protection
screen, proceed carefully in order not to
break the cog.
N
Remove the protection screen (15).
WARNING
Upon reassembly, correctly position the
protection screen in its seat.
Tighten the screw (14) moderately and
carefully, to avoid damaging the protec-
tion screen.
N
Press the bulb (16) slightly and rotate it
anticlockwise.
N
Extract the bulb (16) from its seat.
CAUTION
Insert the bulb in the bulb socket, mak-
ing the two bulb pins coincide with the
relevant guides on the socket.
N
Correctly install a new bulb of the same
type.
CAUTION
If the bulb socket (17) goes out of its
seat, insert it correctly, making the bulb
socket opening coincide with the screw
seat.
use and maintenance SL mille 83