Removing The Inspection Cover; The Lower Handlebar Cover; Scarabeo 100 4T - APRILIA SCARABEO 50 I.E-100 4T - 2001 Manual

2
1
REMOVING THE LOWER
HANDLEBAR COVER
Carefully read page 47 (MAINTENANCE).
Position the vehicle on the centre stand,
on a solid and level surface.
Unscrew and remove the two screws (1)
shown by the arrows.
Unscrew and remove the two screws (2).
CAUTION
Proceed with care to avoid damaging the
tang (4) seat (3).
Using a small screwdriver, lift the tang
(4) found inside the front handlebar cover
(5).
Repeat the above operation also on the
lower part of the handlebar cover.
4
1
Handle the plastic or painted components
with care and avoid scraping or damag-
ing them.
Remove the front handlebar cover (5) tak-
ing care not to break the tangs.
NOTE
On reassembly, check that the tangs
are fitted properly.
5
3
CAUTION
use and maintenance Scarabeo 50
REMOVING
THE INSPECTION COVER
Carefully read page 47 (MAINTENANCE).
CAUTION
Handle the painted components with care
and avoid scraping or damaging them.
Position the vehicle on the centre stand,
on a solid and level surface.
Unscrew and remove the screw (6).
Remove the inspection cover (7).

- Scarabeo 100 4T

7
6
65