APRILIA SCARABEO 100 4T - 06-2001 PART8 Manual page 3

REASSEMBLY
Carefully read page 47 (MAINTENANCE).
CAUTION
While reassembling the wheel, be careful
not to damage the brake pipe, the disc
and the pads.
To reassemble the front wheel, proceed as
follows:
Smear a thin layer of grease on the whole
length of the wheel pin (3), see page 90
(LUBRICANT CHART).
Position the wheel between the fork rods,
onto the support (1).
Insert the tang (8) of the odometer trans-
mission (7) in the seat on the wheel hub.
WARNING
Risk of personal injury. Do not use your
fingers to align the holes.
Move the wheel to align the central hole
with the holes on the fork.
7
2
3
Insert the wheel between the rods. Insert
with care the disc in the brake caliper.
Insert the washer (4) between the
odometer transmission (7) and the fork
right-hand rod.
Fully insert the wheel pin (3) and tighten it
manually.
Tighten the wheel pin (3).
Wheel pin nut driving torque:
50 Nm (5.0 kgm).
Pull the front brake lever and repeatedly
push down the handlebar to allow the fork
to sink.
This allows the fork rods to bed properly.
Tighten the screw (2) of the wheel pin
clamp.
Driving torque of the wheel pin clamp
screws: 12 Nm (1.2 kgm).
Make sure that the following components
are not dirty:
4
– tyre;
– wheel;
– brake discs.
After reassembly, pull the front brake le-
ver repeatedly and check the correct func-
tioning of the braking system.
8
Check the wheel centering.
Have the driving torques, centering and
balancing of the wheel checked by your
aprilia Official Dealer, in order to avoid
accidents that may be harmful for you
and/or other people.
use and maintenance Scarabeo 50
CAUTION
- Scarabeo 100 4T 59