APRILIA RSV 1000 R - 2003 Manual page 140

CAUTION
On refitting, ensure that the lens fits
properly into its slot. Tighten the screw
(1) gradually. Do not overtighten or the
shield will damage.
Push down the bulb (3) gently and twist
counterclockwise.
Extract the bulb (3) from its seat.
CAUTION
When fitting the bulb, ensure that the
two locating pegs fit properly into the
slots in the bulb holder.
Install a new bulb of equal rating.
CAUTION
If the reflector (4) comes off its seat,
refit it correctly.
140
use and maintenance RSV 1000 R
1
REPLACING THE LICENSE PLATE
LIGHT BULB
Read page 137 (BULBS) carefully.
Place the vehicle on the stand, see page
82 (PLACING THE VEHICLE ON THE
STAND).
Remove
glove/tool kit compartment cover, see
page 49 (UNLOCKING/LOCKING THE
GLOVE/TOOL KIT COMPARTMENT
COVER).
- RSV 1000 RFACT
USA USA
4
3
the passenger saddle
5
CAUTION
Never pull on the wiring to extract a
bulb holder.
Extract the license plate light bulb holder
(5).
Remove the bulb and fit a new one with
/
equal rating.
NOTE
Ensure that the bulb fits correctly
into the bulb holder.