APRILIA PEGASO 650 IE - 2004 Manual page 29

u Raise and remove the cover (3) together
with the screws (1) and (2).
u Remove the gasket (4).
CAUTION
In order not to spill the brake fluid while
topping up, do not shake the vehicle.
Do not put additives or other subtances
into the fluid.
If you use a funnel or other similar
items, make sure that they are perfectly
clean.
NOTE
In order to reach the "MAX" level,
t o p u p u n t i l c o v e r i n g t h e g l a s s ( 5 )
completely, with the brake fluid reservoir
rim parallel to the ground.
u Top up the reservoir (6) by adding brake
fluid, see p. 93 (LUBRICANT CHART),
until reaching the correct level.
CAUTION
Do not exceed the "MAX" level while
topping up.
It is advisable to top up until reaching
the "MAX" level only with new pads.
Do not reach the "MAX" level with worn
out pads, since this will cause a fluid
outflow when the pads are changed.
u Put back the gasket (4) in its seat
correctly.
u Put back the cover (3).
Screw and tighten the screw (2).
u
u Screw and tighten the screw (1).
WARNING
Check the braking efficiency.
In case of excessive stroke of the brake
lever or reduced efficiency of the
braking system, contact an aprilia
O f f i c i a l D e a l e r , s i n c e i t m a y b e
necessary to bleed the system.
use and maintenance Pegaso 650 I.E. 29