3
4
2
1
REMOVING THE BATTERY COVER
Read page 57 (BATTERY).
NOTE
Place the vehicle on firm and level
ground.
Make sure that the ignition switch is in
◆
position "
".
Raise the saddle, see page 23
◆
(UNLOCKING/LOCKING THE SADDLE).
◆
Remove the moquette carpet from the
helmet compartment.
◆
Loosen and remove the two screws (1).
◆
Remove battery cover from below (2). Take
care not to damage the upper tabs (3).
Disconnect helmet compartment light
◆
connector (4).
Remove battery cover (2).
◆
58
use and maintenance Atlantic 500
5
CHECKING AND CLEANING THE
BATTERY LEAD CONNECTIONS AND
TERMINALS
Remove the battery cover, see (REMOVING
◆
THE BATTERY COVER) at the side.
Ensure that the ignition switch is in the
◆
"
" position.
◆
Make sure that the battery terminals (5)
are:
– in good condition (i.e. show no corrosion
deposits);
– coated with neutral grease or Vaseline.
If necessary:
Disconnect the negative cable (-) first and
◆
then the positive (+) cable.
Clean off any corrosion deposits with a
◆
wire brush.
◆
Reconnect the positive cable (+) first and
then the negative cable (-).
◆
Coat the battery lead connections and
terminals with neutral grease or Vaseline.
6
REMOVING THE BATTERY
◆
Remove the battery cover, see (REMOVING
THE BATTERY COVER) at the side.
◆
Remove the battery breather hose (6).
◆
Rotate the battery (7) rightwards (as indicated
by the arrow) to take it out of its mount.
Disconnect the negative cable (-) first and
◆
then the positive (+) cable.
Remove battery (7) from its seat and place
◆
it on a flat surface, in a dry environment.
WARNING
Once removed, store the battery is a safe
place, out of the reach of children.
◆
Refit the battery cover, see (REMOVING
THE BATTERY COVER) at the side.
CAUTION
Handle with care when the breather hose
is removed, or battery fluid might spill
out.
7