Dell PowerVault MD3200 Owner's Manual page 78

6 To include the contact information of the sender in the e-mail alert, select
Include contact information with the alerts, and type the contact
information.
NOTE:
7 Select the e-mail tab to configure the e-mail destinations.
• Adding an e-mail address—In e-mail address, type the e-mail address,
and click Add.
• Replacing an e-mail address—In the Configured E-mail addresses
area, select the e-mail address to be replaced, type the replacement e-
mail address in E-mail address, and click Replace.
• Deleting an e-mail address—In the Configured E-mail addresses area,
select the e-mail address, and click Delete.
• Validating an e-mail address—Type the e-mail address in Email
address or select the e-mail address in the Configured E-mail
addresses area, and click Test. A test e-mail is sent to the selected e-
mail address. A dialog with the results of the test and any error is
displayed.
8 For the selected e-mail address, in Information To Send, select:
• Event Only—The alert e-mail contains only the event information.
This alert type is the default.
• Event + Profile—The alert e-mail contains the event information and
the storage array profile.
Event + Support—The alert e-mail contains the event information
•
and a compressed file that contains complete support information for
the storage array that has generated the alert.
9 For the selected e-mail address, in Frequency, select:
• Every event—Sends an alert e-mail whenever an event occurs. This is
the default option.
• Every x hours—Sends an alert e-mail after the specified time interval
if an event occurred during that time interval. You can select this
option only if you have selected either Event + Profile or Event +
Support in the Information To Send drop down list.
10 Click OK.
78
Configuration: About Your Storage Array
Including the contact information in the e-mail alert is optional.