Setting Copy Priority; Stopping A Virtual Disk Copy - Dell PowerVault MD3200 Owner's Manual

Setting Copy Priority

You can use the Copy Manager to select the rate at which a virtual disk copy
completes for a selected copy pair. You can change the copy priority for a copy
pair at any of these times:
• Before the virtual disk copy begins
• While the virtual disk copy has a status of In Progress
• When you re-create a virtual disk copy
To set copy priority:
1 In the AMW, select Virtual Disk Copy Manager.
The Copy Manager window is displayed.
2 In the table, select one or more copy pairs.
3 Select Change Copy Priority.
The Change Copy Priority window is displayed.
4 In the Copy priority area, select the appropriate copy priority, depending
on your system performance needs.
NOTE:
and highest. If the copy priority is set at the lowest rate, I/O activity is
prioritized and the virtual disk copy takes longer.

Stopping a Virtual Disk Copy

You can stop a virtual disk copy operation that has an In Progress status, a
Pending status, or a Failed status. Stopping a virtual disk copy that has a
Failed status clears the Needs Attention status displayed for the storage array.
Keep these guidelines in mind when you stop a virtual disk copy:
• To use this option, select only one copy pair in the Copy Manager.
• When the virtual disk copy is stopped, all of the mapped hosts have write
access to the source virtual disk. If data is written to the source virtual disk,
the data on the target virtual disk no longer matches the data on the
source virtual disk.
There are 5 copy priority rates available: lowest, low, medium, high,
Configuration: Premium Feature—Virtual Disk Copy
173