Point-To-Point Configuration; Overview; Figure 20 Example: Point-To-Point Connections - ZyXEL Communications P-791R V2 - V3.40 User Manual

C
H A P T E R

Point-to-point Configuration

This chapter introduces point-to-point connections.

4.1 Overview

You can set up point-to-point connection between two ZyXEL Devices. These connections
offer a cost-effective, high-speed connection for high-bandwidth applications such as
videoconferencing and distance learning. An example is shown below.

Figure 20 Example: Point-to-point Connections

In a point-to-point connection, the DSL ports on the ZyXEL Devices are directly connected to
each other, not to an ISP or the Internet.
A point-to-point connection can use RFC 1483 in bridge mode or ENET
ENCAP in router mode.
In a point-to-point connection, the ZyXEL Devices should use the same VPI,
VCI, multiplexing, and encapsulation method.
P-791R v2 User's Guide
4
55