Tcp/Ip And Dhcp Setup Menu; Figure 101 Menu 3.2: Tcp/Ip And Dhcp Ethernet Setup; Table 60 Menu 3.2: Tcp/Ip And Dhcp Ethernet Setup - ZyXEL Communications P-791R V2 - V3.40 User Manual

Chapter 20 LAN Setup

20.3 TCP/IP and DHCP Setup Menu

From the main menu, enter 3 to open Menu 3 - LAN Setup to configure TCP/IP (RFC 1155)
and DHCP setup. From menu 3, select the submenu option TCP/IP and DHCP Setup and
press [ENTER]. The screen now displays Menu 3.2 - TCP/IP and DHCP Ethernet Setup
as shown next. Not all fields are available on all models.

Figure 101 Menu 3.2: TCP/IP and DHCP Ethernet Setup

Follow the instructions in the next table to configure these fields.

Table 60 Menu 3.2: TCP/IP and DHCP Ethernet Setup

FIELD
DHCP Setup
DHCP
Client IP Pool
Starting Address:
Size of Client IP
Pool
180
Menu 3.2 - TCP/IP and DHCP Setup
DHCP Setup
DHCP= Server
Client IP Pool Starting Address= 192.168.1.33
Size of Client IP Pool= 32
Primary DNS Server= 0.0.0.0
Secondary DNS Server= 0.0.0.0
Remote DHCP Server= N/A
TCP/IP Setup:
IP Address= 192.168.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-2B
Multicast= IGMP-v2
IP Policies=
Edit IP Alias= No
DESCRIPTION
This field enables/disables the DHCP server.
If set to Server, your ZyXEL Device will act as a DHCP server. You should
configure the rest of the fields in this section except for Remote DHCP Server.
If set to Relay, the ZyXEL Device acts as a surrogate DHCP server and relays
requests and responses between the remote server and the clients. The Remote
DHCP Server needs to be set.
If set to None, the DHCP server will be disabled.
This field specifies the first of the contiguous addresses in the IP address pool.
This field specifies the size, or count of the IP address pool.
,
P-791R v2 User's Guide