Ip Policy Routing Example - ZyXEL Communications P-791R V2 - V3.40 User Manual

Table 93 Menu 25.1.1: IP Routing Policy (continued)
FIELD
Action
Gateway type
Gateway addr
Type of Service
Gateway node
Precedence
Log

31.7 IP Policy Routing Example

If a network has both Internet and remote node connections, you can route Web packets to the
Internet using one policy and route FTP packets to a remote network using another policy. See
the next figure.
Route 1 represents the default IP route and route 2 represents the configured IP route.
P-791R v2 User's Guide
DESCRIPTION
Specifies whether action should be taken on criteria Matched or Not Matched.
Press [SPACE BAR] and then [ENTER] to select Gateway addr and enter the
IP address of the gateway if you want to specify the IP address of the gateway.
The gateway is an immediate neighbor of your ZyXEL Device that will forward
the packet to the destination. The gateway must be a router on the same
segment as your ZyXEL Device's LAN or WAN port.
Press [SPACE BAR] and then [ENTER] to select Gateway node to enter the
remote node number of the gateway if you want to have the ZyXEL Device
send traffic that matches the policy route through a specific WAN port.
If you selected Gateway addr in the Gateway type field, enter the IP address
of the gateway to which the ZyXEL Device forwards the packet. The gateway
is an immediate neighbor of your ZyXEL Device and must be on the same
subnet as the ZyXEL Device, if it is on the LAN, or the IP address of a remote
node, if it is on the WAN. Enter 0.0.0.0 to specify the default gateway.
Set the new TOS value of the outgoing packet. Prioritize incoming network
traffic by choosing No Change, Normal, Min Delay, Max Thruput, Max
Reliable or Min Cost.
If you selected Gateway node in the Gateway type field, enter the remote
node number (one to eight) of the gateway to which the ZyXEL Device
forwards the packet. A remote node represents both the remote gateway and
the network behind it across a WAN connection. For more information of how
to set up a remote node profile, see
22.2 on page 185.
Set the new outgoing packet precedence value. Values are 0 to 7 or Don't
Care.
Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the
system log when a policy is executed.
Chapter 31 IP Routing Policy Setup
Menu 11: Remote Node Setup in Section
265