Configuration File Maintenance; Using A Different Configuration File; Resetting To The Factory Default; Figure 121 Enable Rstp Command Example - ZyXEL Communications Dimension ES-3148 User Manual

Dimension ES-3148 User's Guide
• Enable RSTP on the switch.
• Enable RSTP on port 10.

Figure 121 Enable RSTP Command Example

ras(config)# spanning-tree
ras(config)# spanning-tree 10

32.6 Configuration File Maintenance

The following sections shows how to manage the configuration files.

32.6.1 Using a Different Configuration File

You can store up to two configuration files on the switch. Only one configuration file is used at
a time. By default the switch uses the first configuration file (with an index number of 1). You
can set the switch to use a different configuration file. There are two ways in which you can set
the switch to use a different configuration file: restart the switch (cold reboot) and restart the
system (warm reboot).
Use the
boot config
specified). The following example restarts the switch to use the second configuration file.

Figure 122 CLI: boot config Command Example

ras# boot config 2
Use the
reload config
(if specified). The following example restarts the system to use the second configuration file.

Figure 123 CLI: reload config Command Example

ras# reload config 2
Note: When you use the
file index number, the switch saves the changes to the configuration file the
switch is currently using.

32.6.2 Resetting to the Factory Default

Follow the steps below to reset the switch back to the factory defaults.
1 Enter
erase running config
230
command to restart the switch and use a different configuration file (if
command to restart the system and use a different configuration file
command without specifying a configuration
write memory
to reset the current running configuration.
Chapter 32 Command Examples