Table 119 Management > Configure Clone - ZyXEL Communications ES-3124PWR User Manual

Chapter 36 Configure Clone
The following table describes the labels in this screen.
Table 119 Management > Configure Clone
LABEL
Source/
Destination
Port
Basic Setting
Advanced
Application
Apply
Cancel
284
DESCRIPTION
Enter the source port under the Source label. This port's attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports
which are going to have the same attributes as the source port. You can enter
individual ports separated by a comma or a range of ports by using a dash.
Example:
• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
• 2-6 indicates that ports 2 through 6 are the destination ports.
Select which port settings (you configured in the Basic Setting menus) should be
copied to the destination port(s).
Select which port settings (you configured in the Advanced Application menus)
should be copied to the destination ports.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
ES-3124 Series User's Guide