Connecting Pc; Connecting To A Pc - LENCO DVT-1941 Manual

System Connections

Connecting to a PC

Follow the steps and figure below to connect a PC to the unit.
1. Connect one end of the VGA cable to the VGA input jack on the rear panel of the unit and the
other end to the PC.
2. Connect one end of the audio cables to the PC audio input jack on the rear panel of the unit and
the other end to the PC audio output jack.
3. Set the PC's resolution at 1024×768@60Hz.
After connection, turn on the unit and the PC and then press the SOURCE or PC button to select
VGA mode.
- 15 -