Table of Contents
Advertisement
• Check that both Signal 1 and Signal 2 connector is securely connected.
If not, the images cannot be displayed.
2.
Plug the power cord into the power connector on the rear of the
monitor
3.
Lead the power cord and signal cables into the cable holder at the
rear of the monitor.
• When housing the cables into the cable holder, lead them to the cable
entrance side and pinch the projection to open the cable entrance.
• The cables are recommended to lead with slight sag for the smooth motion of
the stand.
Cable Holder
16
2. CONNECTING UP
Projection
Cable Entrance
Advertisement
Table of Contents
