Table of Contents
Advertisement
Value
Explanation
Controls the Start/Stop of external MIDI de-
MIDI Start/Stop
vices (such as sequencers).
Controls the Play/Stop of external MIDI de-
MMC Play/Stop
vices (such as hard disk recorders).
Patch Level Inc1
Increases the patch volume level by 10 units.
Patch Level Inc2
Increases the patch volume level by 20 units.
Decreases the patch volume level by 10
Patch Level Dec1
units.
Decreases the patch volume level by 20
Patch Level Dec2
units.
Switches Hold recording (dubbing) on and
Hold Dly Rec/Dub
off when "Hold" (p. 32) is selected for the
delay type.
When "Hold" is selected for the delay type,
Hold Dly Stop
the performance is instantly stopped.
Switches the preamp SOLO, for both chan-
nel A and B, on and off.
Solo A&B On/Off
* If one of the two channels is off, both will be
turned on.
Switches to the next higher patch number in
Patch Num. Inc
the same bank as the currently selected
patch.
Switches to the next lower patch number in
Patch Num. Dec
the same bank as the currently selected
patch.
Patch Bank Inc
Switches to the next higher bank number.
Patch Bank Dec
Switches to the next lower bank number.
CC#1
Value
Explanation
The pedal is used as the controller set in As-
Assignable
sign (p. 66) for each patch.
Foot Volume
The pedal functions as a "foot volume" pedal.
Patch Level
The pedal is used as the patch level controller.
The pedal is used as a "pedal wah" pedal
Pedal Wah
when Pedal Wah is switched on.
The pedal is used as a "pedal bend" pedal
Pedal Bend
when Pedal Bend is switched on.
Chapter 6 Using Pedals to Control the Effects
Setting the FV (Foot Volume) Operation for
Individual Patches (EXP1/CC#7 Foot Volume)
The manner in which the FV (Foot Volume: p. 55) is
controlled is determined in each individual patch by the EXP
pedal connected to the EXP PEDAL 1 jack or the Control
Change No. 7 (CC#7) transmitted from the FC-200 or other
external MIDI device.
fig.06-0090
1. Press [ASSIGN].
2. Press PARAMETER [
"CC#7 FV" is displayed.
fig.06-0100d
3. Rotate the PATCH/VALUE dial to change the setting's
value.
4. Repeat Steps 2 and 3 as needed.
5. Press [EXIT] to return to the Play screen.
6. To save the settings, use the Write procedure (p. 24).
Parameter/
Range
On/Off
Off, On
Foot Volume Min
0–100
Foot Volume Max
0–100
3
2
5
] [
] so that "EXP1 FV" or
Explanation
Press [ASSIGN] to switch the foot volume
setting on and off.
Sets the volume level when the pedal is
completely released.
Sets the volume level when the pedal is fully
depressed.
1
65
Advertisement
Table of Contents
