Table of Contents
Advertisement
Driver installation and settings (Windows)
Windows 98 users
The USB composite device driver is installed first, then the USB audio device driver is installed.
Use the following procedure to install the drivers.
1
With the GT-PRO disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB mouse (if used).
2
Exit all currently running software (applications).
Also close any open windows. If you are using virus checking or similar software, be sure to
exit it as well.
3
Before connecting the USB cable, switch the GT-PRO's driver mode to "Standard."
For instructions on switching the GT-PRO's driver modes, refer to "Switching the Driver
Mode" (p. 88).
4
Insert the Windows CD-ROM into the CD-ROM drive of your computer, and the power
switch turned OFF, then use the USB cable to connect the GT-PRO to your computer.
5
Make sure that the GT-PRO's OUTPUT MAIN and SUB knobs are set to the lowest setting,
then switch ON the POWER switch.
USB composite device will be detected automatically, and the Add New Hardware Wizard
dialog box will appear.
fig.12-0091
6
Click [Next].
7
When "What do you want Windows to do?" appears, select Search for the best driver for
your device (Recommended), and click [Next].
fig.12-0092
A dialog box like the one shown below will appear.
fig.12-0093
120
Advertisement
Table of Contents
