Message List - Roland DR-880 Owner's Manual

Message List

Buffer full!
Cause 1 : Too many MIDI messages were received
all at once, and the DR-880 was unable
to process all of them.
Action 1 : Reduce the volume of the MIDI messages
being sent by the transmitting device.
Cause 2 : You attempted to play back an excessive
amount of data, and the DR-880 was
unable to process all of it.
Action 2 : Reduce the amount of data being played
back, or slow down the playback tempo.
Checksum Error !
Cause: MIDI Exclusive messages could not be
received correctly during a Bulk Load
operation.
Action: Try the operation again.
File error !
Cause: During an SMF Import, you attempted
to use a file of a type other than those
specified, or one that is invalid.
Action: Use the specified type of file.
Memory full !
Cause: Memory is full.
Action: Save the pattern/song you are creating,
and then delete unneeded patterns or
songs.
MIDI off line !
Cause: A MIDI Active Sensing error has
occurred. An abnormality has been
detected in the device or cable connected
to MIDI IN.
Action: Check the device or cable connected to
MIDI IN.
Not supported !
Cause: You attempted to import SMF data that
the DR-880 does not support.
Action: Check that the SMF is in a format that
can be imported by the DR-880. (p. 135)
148
Now working...
Cause: Data is being processed.
Action: Please wait until the message disappears.
Now writing...
Cause: Data is being saved to memory.
Action: Never turn off the power while this
message is displayed.
* If you turn off the power while this message is displayed,
it is possible that previously saved data (in addition to the
data now being written) will also be lost.
Too Busy !
Cause: The system attempted to concurrently
process abnormally large amounts of
data, but was unable to succeed.
Action: Make sure that the unit is not being
forced to handle an overly large amount
of data (in patterns, or received MIDI
messages) all at once, and try to reduce
the amount of data.
Use pattern mode
Cause: You attempted to use EZ Compose or
Groove Modify in Song mode.
Action: Switch to Pattern mode before using EZ
Compose or Groove Modify.
User data is damaged. Factory Reset
Cause: The data in the DR-880's internal
memory is damaged. (This message will
appear when you turn on the power.)
Action: Press [ENTER] to reset the DR-880 to the
factory-set condition.
System Error !
Cause: An unknown error has occurred in the
system.
Action: Immediately stop using the unit, and
consult your dealer or nearest Roland
Service Center.