Restoring The Factory Settings (Factory Reset); Adjusting The Expression Pedal - Boss GT-6B Owner's Manual

Restoring the Factory
Settings (Factory Reset)
Restoring the GT-6B to the settings made at the factory is
referred to as "Factory Reset."
Not only can you return all of the settings to the values in
effect when the GT-6B was shipped from the factory, you can
also specify the range of settings to be reset.
fig.11-201
2 1
1. Turn off the power.
2. While holding down COMP/LIMITER ON/OFF button
and [TYPE VARIATION], turn on the power.
The Factory Reset range setting screen appears in the
display.
fig.11-202
The area of data you wish to factory reset
* To cancel the Factory Reset, press [EXIT].
3. Press PARAMETER [
and rotate the PATCH/VALUE dial to specify the range
of settings you want to restore to the factory settings.
System:
System parameters, Harmonist scales, Auto Slap phrases
and overdrive/distortion, and wah custom edit
parameters
#U1-1–#u0-4:
Settings for patch Numbers U1-1 through u0-4
4. If you want to proceed with the factory reset, press
[ENTER].
The specified range of data is restored, and the Play
screen returns to the display.
3
3
4
] [ ] to move the cursor,

Adjusting the Expression Pedal

Although the GT-6B's expression pedal has been set for
optimum operation at the factory, extended use and the
operating environment can result in the pedal going out of
adjustment.
If you encounter problems such as being unable to fully cut
off the sound with the volume pedal, you can use the
following procedure to readjust the pedal.
1. Hold down [PEDAL ASSIGN] while you switch on the
power.
The following messages alternate in the display.
fig.11-601
2. With the pedal completely released, press [WRITE].
The message "---OK! ---" appears, and then the following
messages alternate in the display.
fig.11-602
* If you press [WRITE] when the pedal is not completely
released, or when the pedal position (angle) is not correct, the
message "--- Area Over! ---" appears in the display, and you
are prevented from proceeding to the next step. If this occurs,
readjust the pedal position.
3. With the pedal fully depressed, press [WRITE].
"--- OK! ---" appears, followed by "press [EXIT]."
* If you press [WRITE] when the pedal is not fully depressed, or
when the pedal position (angle) is not correct, the message "---
Area Over! ---" appears in the display, and you are prevented
from proceeding to the next step. If this occurs, readjust the
pedal position.
4. Press [EXIT].
After the message "Checking data please wait..." has
been displayed, the Play screen returns to the display.
Appendices
73