Language Selection; Setting Up Autopilot, Ais And Navtex - Raymarine E90W Installation Instructions Manual

5.6 Language selection

The system can operate in the following languages:
English (US) English (UK)
Danish Dutch
French German
Italian Japanese
Norwegian Portuguese
Spanish Swedish
1. Press the MENU button to open the setup menu.
2. Select the System Setup > Language menu.
3. Select from the languages available.
System checks

5.7 Setting up Autopilot, AIS and Navtex

Some setting up is required to enable integration of Autopilot, AIS
and Navtex equipment connected as part of your system.
Chinese
1. Check the system integration settings.
Finnish
Greek
Korean
Russian
Turkish
2. Check the display presentation settings.
Further changes to the system set up can be made as required,
however most other equipment will operate to a default level without
further configuration.
i. Access the Menu > System Setup > System Integration
menu
ii. Autopilot control. This option should be Enabled if you wish
to control a compatible autopilot using the display.
iii. NMEA port settings. These should be set appropriately for
the connected devices.
iv. Bridge NMEA heading. This should be set ON only if the
display is used as a source of heading data for other devices
connected on SeaTalk or SeaTalk
The AIS presentation layer must be turned ON in order to display
targets.
i. Select the 2D Chart Layers from the chart window
ii. Select AIS Targets On or Off as appropriate.
ng .
59