Assembling The Mounting Hardware And Mounting The Plasma Display - Pioneer PDP-433CMX Technical Manual

Wall-mounted tiltable plasma display hardware PDK-5011

4.6.3 Assembling the mounting hardware and mounting the plasma display

1 Remove the special screws (2 locations) from the bot-
tom of the hung on wall unit.
Special screws (M6)
2 Remove the hardware on the wall side and the hard-
ware on the PDP side.
PDP side hardware
3 Attach the PDP side hardware to the plasma display.
Warning
• Cover the display with a sheet or similar protective
material to protect it from scratches or other dam-
age.
• Be sure to attach it on top of a flat table or similar
surface.
Plasma display
Top side of plasma display
82
Wall side hardware
PDP side hardware
[503CMX/503MXE : 433CMX/433MXE]
4 Fix the plasma display to the PDP side hardware with
bolt M8 (6 locations).
Usually, use the holes marked with the red triangle
"%".
If the 43-inch model is installed with an inclination of
18° or more, the top part of the screw used to adjust
the angle may be visible from a horizontal position in
front of the screen. In this case, you can hide the top
of the screw by using the holes without a red triangle
mark "%".
Top side of plasma display
Warning
Be sure to install the speaker at this stage.
For the installation method, refer to the speaker in-
struction manual.
5 Attach the wall side hardware to the wall.
Install the wall side hardware (4 locations) symmetri-
cally on the left and right side (one at each location
from the center of the
and bolts used to do this are different according to the
wall strength and wall material, purchase suitable
screws and bolts separately.
Warning
Check the strength of the wall and beams before in-
stalling the display.
). Because the screws
Warning